Whole-House Rewiring Cost in 2026: Price Breakdown
Key Takeaways
- Whole-house rewiring costs $10,000 to $15,000 on average in 2026, with a $3,500 floor and bills past $30,000 on large or complex homes.
- New wiring runs about $6 to $8 per linear foot, and heavy-duty circuits push that to $8 to $10 per foot.
- Home size is the biggest price driver: a 1,000 sq ft home may cost $2,000 to $6,000, while a 3,000 sq ft home can reach $12,000 to $20,000.
- A 200-amp panel upgrade adds $2,500 to $4,500, and drywall patching after the work can add thousands more.
- A home warranty does not pay to rewire a whole house, but it can cover a later failure of your electrical system from normal wear.
Whole-house rewiring cost in 2026 runs $10,000 to $15,000 for a typical single-family home, or roughly $6 to $8 per linear foot of new wire. Small homes and partial jobs can start near $3,500, while large homes, finished walls, and a panel upgrade can push the total past $30,000. The three numbers that decide your bill are the square footage of the home, the amount of wire the electrician has to pull, and how much wall and ceiling repair the job leaves behind. This guide breaks down each one so you can budget with real figures instead of guesses.
How much does whole-house rewiring cost in 2026?
Whole-house rewiring is the full replacement of a home’s electrical wiring, and it costs $10,000 to $15,000 on average in 2026. Most homeowners pay between $10,000 and $15,000, with a realistic range of $3,500 on the low end to more than $30,000 for large or hard-to-access homes. Price moves with home size, wire footage, accessibility, and the finish repairs that follow.
| Home size | Typical 2026 rewiring cost | Notes |
|---|---|---|
| 1,000 sq ft | $2,000 to $6,000 | Condo, small ranch, or partial job |
| 1,500 sq ft | $4,000 to $9,000 | Starter home or small two-story |
| 2,000 sq ft | $6,000 to $12,000 | Most common single-family range |
| 2,500 sq ft | $8,000 to $15,000 | Larger two-story with more circuits |
| 3,000+ sq ft | $12,000 to $20,000 | Multi-level or older home with plaster walls |
These ranges assume standard access through attics, basements, and crawl spaces. Homes with finished walls, plaster, or limited access sit at the high end because the crew spends more hours fishing wire and patching afterward. Cost figures here follow industry data compiled by Inch Calculator’s 2026 rewire cost guide.
What is whole-house rewiring?
Whole-house rewiring is the process of removing a home’s old electrical wiring and installing new wire, boxes, and often a new service panel throughout the structure. It replaces aging or unsafe conductors, such as knob-and-tube or aluminum branch wiring, with modern copper circuits that meet current code and carry today’s electrical loads safely.
A full rewire usually includes new branch circuits, outlets, switches, junction boxes, and grounding, plus a panel upgrade when the existing service cannot handle the new load. It is different from a repair, which addresses one failed circuit or device. For how the wiring and the panel relate, our guide on electrical panel replacement cost covers the service equipment in detail.
What drives the cost of rewiring a house?
Rewiring cost is driven by the measurable scope of the job: the length of wire pulled, the labor hours required, the service panel, permits, and the repairs that put your walls back together. Each factor adds a predictable amount, so a clear estimate should itemize them rather than quote one lump sum.
- Wire and materials: $6 to $8 per linear foot for standard wire, or $8 to $10 per foot for heavy-duty circuits feeding ranges, dryers, or a sub-panel.
- Labor: electricians charge roughly $50 to $100 per hour, and fishing wire through finished walls multiplies those hours.
- Service panel: a 100-amp panel runs about $1,100, while a 200-amp upgrade adds $2,500 to $4,500.
- Permits and inspections: $50 to $350 or more, depending on your municipality and the number of required inspections.
- Wall and ceiling repair: drywall patching, plaster work, and paint can add thousands, especially in a finished or historic home.
| Cost component | 2026 price range |
|---|---|
| Standard wiring (per linear foot) | $6 to $8 |
| Heavy-duty wiring (per linear foot) | $8 to $10 |
| Electrician labor (per hour) | $50 to $100 |
| 100-amp panel | About $1,100 |
| 200-amp panel upgrade | $2,500 to $4,500 |
| Permits and inspections | $50 to $350+ |
Signs your home needs rewiring
Signs that a home needs rewiring are the warning symptoms of wiring that can no longer carry its load safely. Flickering lights, warm outlets, a burning smell, and breakers that trip often all point to circuits that are overloaded, degraded, or outdated, and they are reasons to have a licensed electrician inspect the system.
- Breakers that trip repeatedly or fuses that blow often, which our guide on why a circuit breaker keeps tripping explains in depth.
- Outlets or switch plates that feel warm, are discolored, or spark when used.
- A persistent burning or fishy odor near outlets, which can signal overheating wire.
- Two-prong ungrounded outlets, knob-and-tube wiring, or aluminum branch wiring in homes built before the mid-1970s.
- Frequent reliance on extension cords and power strips because there are too few circuits.
Older homes carry these risks most often. Buyers weighing an older property should read our overview of home warranties for older homes, and the U.S. Department of Housing and Urban Development’s home-buying resources cover inspections before purchase.
How to budget for a whole-house rewire
Budgeting for a rewire means turning a single scary number into a planned, itemized project you can finance and schedule. The steps below help you get accurate bids, avoid surprise charges, and decide whether to rewire all at once or in phases.
- Get at least three itemized bids from licensed, insured electricians, each listing wire footage, labor, panel, permits, and repair separately.
- Ask each electrician to confirm whether a panel upgrade is included or quoted on top of the rewire.
- Request a written scope that states who patches drywall and paint, since this is a common hidden cost.
- Consider phasing the work by floor or by circuit priority if your budget cannot cover the full job at once.
- Set aside a 10% to 15% contingency for surprises found once walls are opened, such as prior unpermitted work.
For the bigger picture of what major home systems cost to maintain and replace, our 2026 home repair cost budget guide puts rewiring in context with other large projects.
Does a home warranty cover rewiring?
A home warranty does not pay to rewire an entire house, because a full rewire is a planned upgrade rather than a sudden mechanical failure. A home warranty will not fund a whole-house rewire, but a plan with electrical coverage can help pay to repair a covered part of your wiring or electrical system when it fails from normal wear and tear.
Empire Home Protect plans with electrical coverage are built for failures such as a bad breaker, a failed circuit, or faulty wiring inside the walls that stops working during the plan term. Coverage is applied toward the diagnosed failure, and a covered repair is carried out by an independent service technician. Pre-existing problems, code upgrades, and improvements are excluded, which is why a full rewire of outdated wiring is not a warranty item. Our guide on whether a home warranty covers electrical systems explains exactly where coverage starts and stops, and comparing plans against the best home warranty companies helps you find the right electrical protection.
Frequently Asked Questions
Common questions homeowners ask about the cost and value of rewiring a house in 2026.
How much does it cost to rewire a 2,000 square foot house?
Rewiring a 2,000 square foot house typically costs $6,000 to $12,000 in 2026. The final price depends on how much of the work runs through finished walls, whether a 200-amp panel upgrade is included, and how much drywall and paint repair the job requires afterward. Homes with open attics and basements fall toward the low end.
Is it worth rewiring an old house?
Rewiring an old house is usually worth it when the wiring is knob-and-tube, aluminum, or failing, because outdated wiring is a fire risk and can block insurance or financing. A rewire modernizes safety, adds capacity for today’s appliances, and can raise resale value. If only one or two circuits are the problem, a targeted repair may be enough instead.
How long does it take to rewire a house?
A whole-house rewire usually takes 3 to 10 days for an average single-family home. Smaller homes with accessible attics and crawl spaces finish faster, while large homes, plaster walls, and occupied houses take longer. Drywall patching and painting add more days on top of the electrical work and are often handled by a separate trade.
Can you rewire a house without removing drywall?
Electricians can often rewire much of a house without removing full sheets of drywall by fishing new wire through walls and cutting small access holes. Completely finished homes with insulation or fire blocking still require more openings, which raises labor and patch costs. The amount of wall that must be opened is a major reason two rewiring quotes can differ.
Does homeowners insurance cover rewiring?
Homeowners insurance generally does not cover rewiring for age or code reasons, since routine upgrades and wear are excluded. Insurance may help if faulty wiring causes a sudden covered event such as a fire, but it will not fund a planned rewire. A home warranty is also not a rewire fund, though it can cover a sudden electrical failure from normal use.
Protect your home’s systems with Empire Home Protect
A rewire is a one-time project, but electrical failures can happen any year you own the home. A home protection plan helps you handle those surprise repairs without draining savings. Compare coverage and pricing now: explore Empire Home Protect plans or get a fast, free personalized quote to see what electrical and systems coverage would cost for your home.
Related Articles
Keep reading for more on electrical costs, coverage, and maintenance from the Empire Home Protect blog.
- Electrical Panel Replacement Cost in 2026: What to Expect
- Does a Home Warranty Cover Electrical Systems? (2026)
- Why Your Circuit Breaker Keeps Tripping: Causes & Fixes
- Electrical Panel Maintenance Guide for Homeowners
